![]() ![]() Scroll a bit further down to the Welcome and Goodbye messages, change these to suit your requirements. Note: There is also an imonlcd driver I tried this initially but I just got garbled text on the display. Scroll down to the section and change this line from: I then read the relevant parts of the LCDProc user manual here.Ģ. To double check which VFD unit you have from terminal typeīus 002 Device 003: ID 15c2:0036 SoundGraph Inc. I also started a thread about it here on the XBMC forum. ![]() I am not going to cover the setup of the remote control here as I had allot of problems with it.Īnyways I am looking at the LCD display today not the remote control setup. You can see some comments I made on that thread here. I followed this user guide here and the “Do everything completely in-kernel”” option to get the MCE (Logitech Harmony) remote control working properly. I had installed LIRC initially and I think that and the inbuilt modules in the kernel for iMon where conflicting, in the end I uninstalled LIRC and only used the in kernel modules. I already have the IR receiver working in MCE mode, I did have difficulties with this and was having issues with double presses / commands from the remote being sent to XBMC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |